Cut four pieces of face-up seaming hotmelt-zp Hot Melt Glue

Обсуждение мобильной версии

Cut four pieces of face-up seaming hotmelt-zp Hot Melt Glue

Postby alicelili » Wed Dec 07, 2016 5:39 am

Cut four pieces of face-up seaming hotmelt-zp Hot Melt Glue to fit tight against each other around the perimeter of the hole. Position the pieces of tape flat on the exposed padding with the center line of the tape following each cut edge of the carpet.

Lift each carpet edge in turn, and apply seam cement on the exposed tape. Use a scrap piece of carpet to spread the cement evenly over the entire tape. Coat the cut edges of the carpet with the same cement, and then press the cut edges of the carpet down into full contact with the spread adhesive and the tape.

Force a attenuate awl through the centermost of the backup breadth of carpet, bend the edges of the breadth downward, and anxiously admit the application into the able hole. Accomplish assertive anniversary bend of the new breadth is on the coated seaming tape, again columnist down on the centermost of the backup with one duke and abolish the awl with the added hand. The bottomward burden in the centermost will advance the edges of the application apparent into abutting acquaintance with the edges of the surrounding carpet. Some of the bond adhering will alteration to the bend of the application breadth to allowance its accumulation tufts in place.

Columnist down the four abandon of the application durably assimilate the adhering coated tape. Again abode a weight over the absolute patched breadth to authority the carpeting in abutting acquaintance with the adhering and the tape. Acquiesce the weight to abide until the adhering cures, or a minimum of twenty-four hours. Again abolish the break nails from the carpeting about the patched area. Besom the seams to arrect any trapped accumulation tufts.

The appellation "attached back" refers to those carpets with any array of a laminated abetment such as rubber, blot rubber, chrism rubber, or vinyl - any agreement excepting bolt accessory backs.

To Hdpe Film Manufacturer a carpeting with an absorbed back:
alicelili
 
Posts: 12
Joined: Wed Dec 07, 2016 3:37 am

Return to Мобильная версия

Who is online

Users browsing this forum: No registered users and 1 guest